Display Devices PL-3060 Series Flat Screen Lifts Ceiling User Manual
Page 4
IP406-001 RevC
PL3060 Lift Installation
02/06/07
Thor/Sales Info/Installation Materials/PL3060 Installation
Programming Show Position
Programming can only be done with three-button control. If other methods of triggering the lift are
normally used, first program the lift with the buttons and then configure lift for the other trigger method.
1.)
Press ‘HOME’ button. Unit rises to the home or stored position.
2.)
Press and hold ‘STOP’ button for 10 seconds – unit is now in manual mode.
3.)
Press ‘SHOW’ button momentarily – unit will travel down. When unit reaches desired show
position, press ‘STOP’ button momentarily. THIS MUST BE DONE IN ONE MOTION, DO NOT
PRESS HOME, SHOW, OR STOP FOR FINE TUNING OF POSITION.
4.)
Press and hold ‘STOP’ button for 10 seconds.
5.)
Press ‘HOME’ button momentarily – unit will travel to home position.
6.)
Lift is now set – press ‘SHOW’ button to verify – unit should travel down to show position. If
you start this procedure and wish to quit after step 2, you must reset power to lift before
normal operation (unplug unit or reset electrical breaker.
Control Interface
Low Voltage Control Lines:
There are three integrated methods of control and two optional methods. The standard controls are
three momentary buttons (contacts) or low voltage control signal, or single latching contact. The optional
methods are remote IR or RF control; please contact DDI for information on those options.
Three button control:
‘Home’ button (BLACK) Pin 6
‘Show’ button (RED) Pin 5
‘Stop’ button (GREEN) Pin 1
Common (WHITE) for all buttons Pin 4
Low voltage (5 vdc < V < 24 vdc) control signal:
Jumper Pin 6 to Pin 4, and jumper Pin 5 to Pin 4
Trigger Voltage to Pin 2
Trigger Voltage ground Pin 4.
(applied voltage sends lift up, no voltage sends lift down)
Single latching contact:
Jumper from Pin 6 to Pin 4, and jumper Pin 5 to Pin 4
Contacts between Pin 3 and Pin 2
(contact closed sends lift up, contact open sends lift down)
4 3 2 1
8 7 6 5
Control Box
Side View