Dream Property DM7020 - Manual (Page 20)

- 20 -
18. Satellite Configuration
Press the MENU-Button to enter the OSD-Mainmenu.
Go to (6) Setup -> (2) Service Searching -> (1) Satellite Configuration.
Navigate to the upper Dropdown list and choose your
appropriate Satellite Configuration and press the OK-
Button. Choose your Satellites the Dish is adjusted to
and press the green Option-Button to save
configuration.
This Configuration might differ from yours.
19. Satfind
Press the MENU-Button.
Go to (6) Setup -> (2) Service Searching -> (2) Satfind.
Choose from the lower Dropdown lists your preferred
satellite and transponder.
Adjust the Dish towards the desired satellite until you
have a high value on the Signal strength AGC and on
the Signal quality SNR indicator. The BER should
always indicate a value of zero if the Satellite is locked
and synced.
SNR: Signal to Noise Ratio
This Indicator shows the Quality of the Signal.
AGC: Automatic Gain Control
This Indicator shows the Strengh of the Signal.
BER: Bit Error Rate
This Indicator shows the Errors Rate of the Signal.