Dream Property DM7020 - Manual (Page 21)

- 21 -
20. Motor Setup
Press the MENU-Button to enter the OSD-Main menu.
Go to (6) Setup -> (2) Service Searching -> (3) Motor Setup.
Before proceeding with the Motor Setup refer to
passage Satellite Configuration and choose from the
upper Dropdown list
"
many satellites via DiSEqC
Rotor
"
and press the OK-Button, if you setup a Motor
for the first time.
All possible satellites will be listed. Press the green
Option-Button to save this configuration.
After saving the Configuration, choose (3) Motor
Setup from the Menu Service Searching and press the
OK-Button. The Menu Motor Config appears.
Refer to the Rotors Manual for correct values
degrees/second. If unsure, set a check in front of
"
Use
Motor Input Power
"
and enter the maximum current
the Motor is using for turning to the Dish.
Visit the Website http://www.heavens-above.com to
figure out your geographical location. Enter the values
for Longitude and Latitude and press the green
Option-Button to save.
Proceed to passage Automatic Multisat Scan.