Dream Property DM7020 - Manual (Page 38)

- 38 -
35.2. Communication (Network, WAN (DSL) Setup)
Press the MENU-Button to enter the OSD-Mainmenu.
Go to (6) Setup -> (6) Expert Setup -> (1) Communication Setup.
Navigate to Type, press the OK-Button and select
WAN(PPoE). Use this Type of Connection only, if the
Dreambox is connected directly to a DSL Modem.
T-DSL is used to enter the Account information only
for German T-Com users.
Login:
Enter the Loginname provided from your ISP
(Internet Service Provider).
Password:
Enter the Password provided from your ISP.
The Dreambox provides firewall functionalities on the
following Ports:
80 HTTP, 23 Telnet, 137, 138, 139 Samba and 21
FTP. Uncheck the desired Checkbox to allow
incoming connections.
35.3 NGrab Streaming Setup
Press the MENU-Button to enter the OSD-Main menu.
Go to (6) Setup -> (6) Expert Setup -> (2) Ngrab Streaming Setup.
Ngrab Server is used to record a movie over the
Network to another PC. First install the Ngrab Server
Software on a PC and configure it referring the
manual from the Software.
Srv IP:
Enter the IP-Address of the PC on which the Ngrab
Server Software runs.
Srv Port:
Enter the Server Port-Address which is configured in the Ngrab Server Software.
The MAC-Address is used for the WOL (Wake On LAN) function, which must be supported by the PC’s
NIC (Network Interface Card). This is a pretty good feature, because you can configure a PC to use full
APM (Advanced Power Management). The PC awakes upon access through the NIC and the Ngrab
recording starts.
Srv MAC:
The Ngrab Server Software must be started and
configured, before detecting the MAC-Address of the
PC. Press the blue Option-Button to start
detecting.