Dream Property DM800 HD PVR - Manual (Page 12)

- 12 -
U s e r M a n u a l D r e a m b o x D M 8 0 0 H D P V R
Serial port (RS232C, Sub-D, 9-pol.)
The Serial Port is used to update the operating system. Please connect a serial null modem
cable here.
Network interface (Ethernet 10/100Mbit, RJ45)
The Communication Port is an Ethernet port. It is used to communicate with your Dreambox
via HTTP, FTP, NFS, Telnet and Samba to access your recorded movies, to upload channel
lists, etc. This port is also used to update the operating system of your Dreambox. Please
use a regular patch cable to connect your Dreambox to your LAN.
DVI output
You can connect a TV to the DVI out of your Dreambox if your TV has the right input.
USB 2.0 ports
The USB 2.0 Port is designed for devices that support the USB 2.0 standard. The amount of
supported USB devices depends on the installed image (Software) and is still under
development.
TV Scart
Connect your TV, projector or beamer to your Dreambox using a Scart cable.
Power supply connector
Plug the power cable of the power supply that came with your Dreambox into power outlet.
Connect your power supply to your Dreambox. You must not connect the power plug of the
power supply to anything other than a socket that supplies 230V/50Hz.
Digital audio output (Toslink)
You can connect your Dreambox with an optical (Toslink) cable to your HiFi-Amplifier or
DSP. The AC3 signal is also available at this port in case the selected channel transmits
Dolby Digital signals.