Electrocompaniet ECM 2 - Manual (Page 28)

28
ENG
Settings
Settings - Network
Information
Configure wired
Select the networking type of your wired connection by pressing the “OK“ button. You can configure the
IP address, Gateeway, Subnet mask and DNS using on screen keyboard.
Configure wireless
Select the “Configure networking type” button and press “OK“ for establishing the wireless connection.
Choose preferable network from an on-screen pop-up menu and press the “OK” button. Follow the further
on-screen instructions.
Settings - Output Settings
Audio
• Internet access
Status information about your Internet connection.
YES – Internet available
NO – no Internet connection available
• Wired connection
Status information, Mac address and IP address of your wired network connection.
• Wireless connection
Status information, Mac address and IP address of your wired network connection.
This setup menu provides options to set/change your audio output settings.
(Please refer to Connecting audio section for detailed explanation about the
different audio output options provided with your ECM)
• Volume normalisation (volume adjustement)
When volume normalization is enabled the unit will read the ReplayGain tag in your
audio files and normalize the sound level accordingly. You can choose between
track levels and album levels.
• Audio output
Allows you to select between analogue/SPDIF and digital (HDMI) output. Choose
analogue/SPDIF if you plan to connect the balanced XLR outputs or the digital SPDIF
to your amplifier. Select HDMI if you connect digital to your home cinema receiver
or TV. For best audio and video performance connect your ECM using the balanced
analogue outputs to your amplifier and the HDMI output to your TV. Make sure ana-
logue/SPDIF is selected in this case.
• Speaker configuration
(Only selectable if Audio output is set to HDMI)
Select the supported speaker configuration of your Home Cinema Receiver/ decoder.
Example: If your Home Cinema Receiver supports 5.1 channel and you have con-
nected all 6 speakers you select 5.1 on your ECM. If you use 5 speakers without
subwoofer you select 5.0.
-Dolby Digital(AC3) capable receiver (Only selectable if Audio output is set to HDMI)
Select if you use a Dolby Digital(AC3) capable receiver.
-DTS capable receiver (Only selectable if Audio output is set to HDMI)
Select if you use a DTS capable receiver.
-AAC capable receiver (Only selectable if Audio output is set to HDMI)
Select if you use a AAC capable receiver.