Elenco Radio Controlled Car Soldering User Manual
Page 12
Advertising
-11-
Screw Used
(shown actual size)
0.4” x 0.1”, 0.15” head
X2
0.4” x 0.1”, 0.15” head
Screws
Rear Section
Cover
NOTE: Make
sure that the wires
from the ON/OFF switch
and the motor run out of
the rear section cover
through the slots (as
shown) without being
damaged.
6
Quick Test: Lift the wheels off the ground so they
may spin freely. Connect a 1.5V battery across the
motor wires with your hands, (+) terminal to green
wire. The wheels should spin forward slowly but
smoothly. Reverse the wires to the battery and the
wheels should spin backwards.
Note: Try to also press down on the forward part of
the rear cover while doing this, since the forward
screws for it have not been installed yet.
Advertising