Elenco Radio Controlled Car Soldering - Manual (Page 14)

-13-
Motor Gear
Right Front Wheel
Left Front Wheel
NOTE: If you
have a problem
putting the gear on
the shaft of the motor,
then gently tap the
gear on with a hard
object.
8
NOTE: The
next 3 steps will be
much easier if you
elevate the car about
1” using a small
object.
NOTE: The gear
should lay on the
teeth of the steering
bar. Add some
Vaseline or grease to
the teeth.
Quick Test: Turning one
wheel by hand should also
turn the other wheel and
move the gear along the
steering bar.
Quick Test: Connect a 1.5V
battery across the motor wires
with your hands - the motor
should spin. Reverse the wires to
the battery and the motor should
spin in the opposite direction.
Side Tab:
bend tab back
180 O and solder
to motor shell
0.01
µ
F Capacitor
(marked 103):
Solder leads to motor tabs, one lead is
also soldered to motor shell.
You cannot get good
connections soldering to
the motor shell unless
you first file or scrape
away a small area of the
outer coating.
Orange Wire
Blue Wire
Steering Motor
(the smaller motor; Blue
wire goes to tab next to
⊕
marking in plastic)
⊕
⊕
Screw Used
(shown actual size)
0.3” x 0.1”, 0.15” head
X2
0.3” x 0.1”,
0.15” head
Screws