Elenco Radio Controlled Car Soldering - Manual (Page 9)

-8-
3
Bottom Frame
Driving Motor
Interior Tab
Side
Tab
Interior Tab:
Bend Tab 90 O ,
but don’t short
to motor shell.
Motor Gear
Quick Test: Connect a
1.5V battery across the
motor wires with your
hands.
The motor should
spin.
Side Tab:
bend tab back
180 O and solder
to motor shell
0.1
µ
F Capacitor
(marked 104):
Solder leads to motor
tabs, one lead is also
soldered to motor
shell.
You cannot get good connections
soldering to the motor shell unless
you first file or scrape away a
small area of the outer coating.
Green Wire
Yellow Wire
Driving Motor
(the larger motor; Yellow
wire goes to tab next to
⊕
marking in plastic)
⊕
⊕
NOTE: If you
have a problem
putting the gear on
the shaft of the motor,
then gently tap the
gear on with a hard
object.