Elenco Radio Controlled Car Soldering - Manual (Page 29)

-28-
HOW TO USE IT
Place the car in a flat, open area, turn the ON/OFF switches in the car and Remote Control to ON, and extend
the antenna on the Remote Control.
The LEFT lever on the Remote Control:
Push forward (or forward-right) to make the RCC-7K go forward.
Push backward to make the RCC-7K go backward.
Push to center or let go to stop.
The RIGHT lever on the Remote Control:
Push left to make the RCC-7K turn left.
Push right to make the RCC-7K turn right.
Push to center or let go to go straight.
NOTE: The light bulb in the car comes on only when the car is moving forwards or backwards.
The RCC-7K operates best on a wood or tile floor or in your driveway. Never operate the car in the street.
These suggestions will help make your car last for years of fun:
•
Never drive your car in rain, snow, mud, sand, dirt, or on a wet floor, as damage may result.
•
Do not drive your car on carpet since lint may damage the wheel mechanism.
THE FCC
The Federal Communications Commission (FCC) regulates use of the radio frequency spectrum in the United
States to prevent products from interfering with each other.
FCC regulations for your RCC-7K require you to accept any interference from authorized sources and that you
shut down if you are causing interference with other authorized products. Contact Elenco
® Electronics if you
need assistance.
You should never modify the electrical circuit components inside your Remote Control transmitter as this may
cause malfunctions or violate FCC regulations for this product.