EXFO FIP-400 Fiber Inspection Probe and ConnectorMax - Manual (Page 22)

Setting up Your Fiber Inspection Probe and ConnectorMax
16 FIP-400
Setting up Autonaming
3. If you are testing single-fiber connectors and have purchased the
analysis option, you can also select a test configuration at this point.
4. Click OK to close the window.
At the bottom of the main window, you can see what mode is currently
active.
Setting up Autonaming
The autonaming feature is useful to make a relevant naming scheme for
your tests. This also ensures that you do not overwrite files by mistake. You
can select which item goes in the file name, as well as the type of separator
you want to use in between.
A preview is available to show you the final output of the file name.
Note: When in multiple-fiber mode, the scheme is only editable prior to the first
acquisition; afterwards, it is available as read-only until you have
completed the inspection for the set number of fibers. If the Fiber ID item is
selected for the autonaming scheme, the file name will display both the
start and end fiber number values.
Single-Fiber Connector
Current fiber in
connector
Multiple-Fiber Connector
Number of fiber results
presently included in
connector result