EXFO FIP-400 Fiber Inspection Probe and ConnectorMax - Manual (Page 30)

Setting up Your Fiber Inspection Probe and ConnectorMax
24 FIP-400
Managing and Selecting Test Configurations (Optional)
To revert to the factory identification settings:
Delete the .xml configuration file.
Note: A new .xml file with the default settings will be created the next time you
start the application.
Managing and Selecting Test Configurations
(Optional)
If you have purchased the analysis portion of ConnectorMax, you can
create and select specific test configurations according to the type of fiber
you are analyzing, the connector type or the type of defect you are looking
for.
Note: If you have purchased the analysis option, some test configurations as per
IEC 61300-3-35 and IPC 8497-1 standards, and other configurations with an
enlarged C zone are available by default.
Creating custom test configurations is done through duplicating an existing
configuration, and then modifying the desired criteria.
If you create configurations on one unit or computer, and want to transfer
them to another unit or computer, you can do so. However, this feature is
not included directly in ConnectorMax, and you must proceed outside the
application.