EXFO FIP-400 Fiber Inspection Probe and ConnectorMax - Manual (Page 33)

Setting up Your Fiber Inspection Probe and ConnectorMax
Fiber Inspection Probe 27
Managing and Selecting Test Configurations (Optional)
3. In the General tab, modify the criteria as needed.

Configuration name: the application suggests a name for the
configuration. You can change it as needed (maximum 100
characters), but if you select a name that already exists, a suffix will
automatically be added so as not to overwrite files.

Connector type: select which type of connector you are using for
your inspection.

Fiber type: Select whether you are inspecting singlemode or
multimode fibers.

Polishing type: Select the type of polishing for the fibers between
APC, PC or UPC.

Analysis mode: Select the type of analysis between Outside plant
(selected by default) and Manufacturing. The manufacturing mode
is more sensitive for scratches and defects detection.

Cladding diameter: This value is set at 125 μm and cannot be
modified.