EXFO FTB-5800 Chromatic Dispersion Analyzer for FTB-400 - Manual (Page 14)

Getting Started with Your Chromatic Dispersion Analyzer
8 FTB-5800
Inserting and Removing Test Modules
To remove a module from the FTB-400 Universal Test System:
1. Exit ToolBox and turn off your unit.
2. Position the FTB-400 so that the left panel is facing you.
3. Turn the retaining screw counterclockwise until it stops.
The module will be slowly released from the slot.
4. Place the FTB-400 so that the right panel is facing you.
5. Hold the module by its sides or by the handle (NOT by the connector)
and pull it out.
Turn retaining screw knob(s)
counterclockwise
FTB-400 left panel
(7-slot unit shown)