EXFO FTB-5800 Chromatic Dispersion Analyzer for FTB-400 - Manual (Page 26)

Setting Up Your Chromatic Dispersion Analyzer
20 FTB-5800
Defining the Automatic Fiber Name Format
Defining the Automatic Fiber Name Format
Each time you make a new acquisition, the fiber name changes
automatically according to a pattern you will have previously defined. This
name is made of a static part (prefix) and a variable part that will be
incremented.
The increment can be positive, negative or null (zero). Entering zero gives
you the opportunity to use the same acquisition fiber name.
Note: The number you can enter will depend on the number of digits you have
specified. For example, if you set two digits, the maximum you can enter
is 99. Once the system reaches 99, it will step back to 00. If the selected
increment is negative, when the system reaches 00, it will step back to 99.
If you do not enter any prefix or number, the fiber will be identified with
one number only.
Note: You can modify the fiber name later, when the acquisitions are complete.
For more information, see Documenting Results on page 59.
Note: You cannot define the automatic fiber name format in offline mode.