Recalling data – EXFO PPM-350C PON Power Meter User Manual
Page 27
PPM-350C
21
Recalling Data
According to the storage configuration you have set using the Handheld Data
Transfer application, you can recall data you have previously stored.
You can recall files according to the following modes, depending on how your unit
was set:
OLT and ONT IDs, with different locations.
Job, where the OLT and ONT are grouped in different locations.
To recall data in OLT mode:
1. Press and hold down
for a few seconds to access the data recall menu.
2. Press
to access the available OLT
values. The OLT name is displayed next
to the Loc. indicator.
3. Press
to select the OLT and switch to the ONT selection.
4. Press
to access the available ONT.
5. Press
to select the ONT or
to exit the recall
mode.
The data is recalled. Press
to go through the data
with the same OLT and ONT values.
To recall data in Job mode:
1. Press and hold down
for a few seconds to access the data recall menu.
2. Press
to access the available Job ID values.
3. Press
to select the job or
to exit the recall
mode.
The data is recalled. Press
to go through the data
with the same Job ID values.
Store/
Select
OLT ID
number
OLT name
Next
Store/
Select
Next
Store/
Select
Next
Store/
Select
Next
Store/
Select
Next