EXFO FLS-2600B Tunable Laser Source - Manual (Page 118)

Remote Control
110 FLS-2600B
Specific Commands
SOURce:SWEep:PAUSe
Description This command allows you to set the minimal pause length
between the steps for the step-by-step sweep.
Syntax SOUR:SWE:PAUS<wsp><state>
Parameters The <state> parameter is the time in the 59:999 ms format.
Example SOUR:SWE:PAUS 30:500
Note You cannot use this command during a sweep.
See also SOUR:SWE:STEP, SOUR:SWE:STEP:LIM:LOW?,
SOUR:SWE:STEP:LIM:HIGH?, SOUR:SWE:STEP?,
SOUR:SWE:PAUS?, SOUR:SWE:PAUS:LIM:LOW?,
SOUR:SWE:PAUS:LIM:HIGH?, SOUR:SWE:TRIG and
SOUR:SWE:TRIG?
SOURce:SWEep:PAUSe?
Description This query returns the minimal pause length between the steps
for the step-by-step sweep.
Syntax SOUR:SWE:PAUS?
Response Time in 59:999 ms format.
See also SOUR:SWE:STEP, SOUR:SWE:STEP:LIM:LOW?,
SOUR:SWE:STEP:LIM:HIGH?, SOUR:SWE:STEP?,
SOUR:SWE:PAUS, SOUR:SWE:PAUS:LIM:LOW?,
SOUR:SWE:PAUS:LIM:HIGH?, SOUR:SWE:TRIG and
SOUR:SWE:TRIG?