Glow-worm Climapro2 RF - Manual (Page 15)

0020094586_01 - 08/10 - Glow-worm
- 13 -
INSTALLATION
10.6 Cooling function
Menu This menu lets you:
Activate or deactivate the cooling function
in the end user menu.
Enable or disable the cooling program in
the end user menu.
10.6.1 Activate or deactivate the cooling function
This function allows the user to activate or deactivate the
cooling menu.
• From the installer menu (see access to the installer menu) >
select on the screen > cooling > on/off
• Press to highlight your choice (activate or deactivate)
and press the button to confirm.
10.6.2 enable or disable the cooling program
The cooling function must be activated before it can
be programmed.
This function makes it possible to allow the user to program
cooling.
• From the installer menu (see access to the installer menu) >
select on the screen > cooling > enable program
• Press to highlight your choice (enable or disable) and
press the button to confirm.
10.7 Options
Menu This menu lets you:
Configure the wireless outdoor
sensor:
- for correcting the measured
outside temperature,
- for choosing the heating curve (see
the instructions for the wireless
outdoor sensor).
Adjust the date and time
Choose the language
Enter the telephone number that will be
displayed in after-sales service messages.
Display information: zone, type and
software version for the room thermostat
10.7.1 Outdoor sensor settings
Correcting the outside temperature
This function lets you rectify the temperature measured by
the room thermostat (by +/- 5 °C with a step of 1 °C - factory
setting: 0).
• From the installer menu (see access to the installer menu) >
select on the screen > settings > outdoor sensor settings
> outside T O correction
• Increase or reduce with the buttons to display the
desired correction and validate with button .
Choosing the heating curve (gradient)
This function lets you choose the heating profile (value
adjustable between 0.2 and 4 - factory setting: 1.6).
• See the installation manual for the outdoor sensor.
• From the installer menu (see access to the installer menu) >
select on the screen > settings > outdoor sensor settings
> select heating curve