GoDEX EZ1105 series - Manual (Page 27)

EZ1105 / EZ1305 User Manual
23
5-4. Troubleshooting
Problem Solution
The printer is switched on
but the LED does not light
up.
♦ Check the power supply.
The LED lights up red and
printing is interrupted.
♦ Check the software settings (driver settings) or
command codes.
♦ Look for the error alert in the table in Section 3-5. Error
alerts.
♦ Check whether the print mechanism is closed
correctly.
The label stock passes
through the printer but no
image is printed.
♦ Please make sure that the label stock is loaded the
right way up and that it is suitable material.
♦ Choose the correct printer driver.
♦ Choose the correct label stock and a suitable printing
mode.
The label stock jams during
printing.
♦ Clear the paper jam. Remove any label material left
on the thermal print head and clean the print head
using a soft lint-free cloth dipped in alcohol.
There is no printed image
on some parts of the label.
♦ Check whether any label material or ribbon is stuck to
the thermal print head.
♦ Check for errors in the application software.
♦ Check whether the starting position has been set
incorrectly.
♦ Check the ribbon for wrinkles.
There is no printed image
on part of the label or the
image is blurred.
♦ Check the thermal print head for dust or other dirt.
♦ Use the internal “~T” command to check whether the
thermal print head will carry out a complete print job.
♦ Check the quality of the print medium.
The printed image is
positioned incorrectly.
♦ Check whether there is paper or dust covering the
sensor.
♦ Check whether the label stock is suitable. Contact
your supplier.
♦ Check the paper guide settings.
A label is missed out during
printing.
♦ Check the label height setting.
♦ Check whether there is dust covering the sensor.
♦ Run the auto-detection function. (3-3. Automatic
detection of label height).
The printed image is
blurred.
♦ Check the darkness setting.
♦ Check the thermal print head for dust or dirt. (See 5-1.
Cleaning the print head)
【 Note 】
If any problems occur that are not described here, please contact your dealer.