GoDEX Ethernet Control Center - Manual (Page 9)

Software Operation Manual 7
On "Port Settings", change the "Protocol" to "LPR". And the "Queue Name" setting must be "USB1_LQ" to
connect your printer properly.
3-3. Wireless Connection
3-3-1. Preliminary
Before you can access wireless network, wireless parameters should be set correctly. You have to
setup the first wireless parameter set through LAN (wired) connection.
Wireless access can be set as:
1. Infrastructure (station) mode, which need an access point to route network messages, or
2. Ad-hoc mode, which connect nearby wireless PC/devices with the same SSID (Service Set ID).
Wireless access can be secured by WEP64, WEP128, or WPA-PSK / WPA2-PSK with TKIP/AES.
In infrastructure mode, if network administrator wants to change any security related parameters,
Network Printer Server should be changed first, and then access point. If parameters mismatch
causes wireless access is not allowed, you have to modify those parameters through LAN connection.
In infrastructure mode, the maximal transfer rate is 54 MBits depending on access point’s capability.
In ad-hoc mode, only 802.11b (the maximal transfer rate is 11 MBits) is allowed by specification.