Golden Blount CSA - Manual (Page 4)

TO INSTALL GAS LOG SET:
1. Attach damper clamp to fireplace damper to keep
damper open a minimum of 3".
2. Put grate in the center and to the rear of fireplace
floor.
3. Position burner under grate so that the burner pipe
is approximately 3" in back of the grate front legs.
Remove grate.
4. Attach aluminum connector to gas supply and
regulator. Note! Be careful not to crimp aluminum
tube when bending. Use soapy water to check
fittings for leaks.
5. Pour silica sand into burner pan completely cover-
ing the pipe burner in pan. Vermiculite to be used
with L.P. sets. Note! On L.P. models be careful not
to pour vermiculite over brass air mixer attached to
burner pan. Air mixer holes must not be obstructed!
6. Spread the black cinders in the front and sides of
the ember bed material to form a picture frame
effect to enhance the overall appearance. Note!
On L.P. models be careful not to pour black cinders
over brass air mixer attached to burner pan. Air
mixer holes must not be obstructed!
7. Evenly spread glowing ember material over the
burner pan and replace grate.
8. Place logs on grate
A. The longest log is the bottom front log.
B. Next longest log is the bottom back log to
be positioned 3" behind the front log.
C. The positioning of top logs is a matter of
the installer’s choice.
Note! Illustration shows 1-piece front log.
Some GB models have 2-piece front logs
or separate log arrangement instructions.
4
IMPORTANT - PLEASE NOTE L.P. GAS MODELS
MODERATE SOOT ACCUMULATION IS CONSIDERED NORMAL FOR
L.P. GAS LOGS. TO KEEP THIS SOOT ACCUMULATION TO A MINI-
MUM, REDUCE THE FLAME IMPINGEMENT BY SPACING FRONT AND
BACK LOGS AS FAR APART AS POSSIBLE, AND BY SPACING ALL
TOP LOGS AS FAR APART AS POSSIBLE.
BURNER
CAP