Golden Blount CSA - Manual (Page 5)

PILOT BURNER ADJUSTMENT
Using a long narrow screwdriver, turn the pilot
adjustment screw (located under the cap screw)
slowly clockwise to reduce the flame, or counter-
clockwise to increase the flame. The adjustment
screw can be turned so that the pilot flame is
completely extinguished. Some tightening of the
adjustment screw may occur during adjustment.
This is normal. The pilot flame should be a soft blue
flame with yellow tipping which encircles the ther-
mocouple tip.
Reassemble the cap screw and gasket to the valve
body, insuring that the cap screw and gasket are
firmly seated on the valve body. Turn the control
knob to the “on” position to assure proper ignition
of the log set.
The pilot burner is pre-set at the factory and should
normally not require any adjustment. However,
should adjustment be necessary, the following steps
should be taken:
With the pilot burner lit and the control knob in the
pilot position, carefully remove the cap screw lo-
cated on the control valve.
FOR YOUR SAFETY, READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion
may result causing property damage, personal injury or loss of life.
A. The Golden Blount Gas Log Set has a pilot
which must be lighted by hand. When lighting the
pilot, follow these instructions exactly.
B. BEFORE LIGHTING, smell all around the gas
log set area for gas. Be sure to smell next to floor
because some gas is heavier than air and will settle
on the floor.
WHAT TO DO IF YOU SMELL GAS
* Do not try to light any appliance.
* Do not touch any electrical switch, do not use any
phone in your building.
* Immediately call your gas supplier from a neighbor’s
phone. Follow the gas supplier’s instructions.
* If you cannot reach your gas supplier, call the fire
department.
C. Use only your hand to push in or turn the gas
control knob. Never use tools. If the knob will not
push in or turn by hand, don’t try to repair it. Call a
qualified service technician. Force or attempted
repair may result in fire or explosion.
D. Do not use the gas log set if any part has been
underwater. Immediately call a qualified service
technician to inspect the gas log set and to replace
any part of the control system and any gas control
which has been under water.
DAMPER CLAMP INSTRUCTIONS
The Damper Clamp should not be used unless it will
provide the permanent vent opening listed on the
table found on page 2.
The Damper Clamp with set screw is provided as
a means to prevent full closure of the damper blade.
The Clamp is easily attached to most damper
blades with pliers or wrench, and must be perma-
nently installed. The Clamp is designed to prevent
accidental closure of the damper when installed as
illustrated.
Should the Clamp not fit, have a permanent stop
installed, remove the damper blade or have the
damper cut to provide the minimum permanent
opening required.
5
CONTROL
KNOB
PILOT FLAME
ADJUSTMENT