Golden Blount BIG TEX - Manual (Page 5)

5
HIGH OUTPUT GAS CONROL VALVE LIGHTING INSTRUCTIONS
1. “Stop!” First read the safety information at the left.
2. Turn the control to the “OFF” position. To do this, you
must turn the knob clockwise to the PILOT position
and then press in and continue turning clockwise
to the “OFF” position.
3. WAIT FIVE (5) MINUTES TO CLEAR OUT ANY GAS.
If you then smell gas, STOP! Follow step “B” in the
safety information at the left. If you don’t smell gas, go
to the next step.
4. To put the control in the pilot position, turn the control
knob counter-clockwise to the “PILOT” position.
5. To light the pilot, depress the control knob and light the
pilot using a long match or extended butane lighter. The
control knob should be held IN for 1 minute.
6. Release the control knob. The pilot should remain lit
after releasing.
7. Turn the control knob counter-clockwise to the
“ON” position and turning on switch or remote attached
to the “TH” and “TH-PG” terminals on valve.
To Turn Off Gas To Applicance
1. Turn off switch or remote.
2. Turn control knob clockwise to “PILOT”.
3. Depress control knob slightly and turn clockwise
to “OFF”.
Pilot burner location
LP Gas models
Pilot burner location
Nat. Gas models
Gas Control Knob
FOR YOUR SAFETY,
READ BEFORE LIGHTING
WARNING: If you do not follow these
instructions exactly, a fire or explosion
may result causing property damage,
personal injury or loss of life.
A. The Golden Blount Gas Log Set has a pilot which
must be lighted by hand. When lighting the pilot,
follow these instructions exactly.
B. BEFORE LIGHTING, smell all around the gas log set
area for gas. Be sure to smell next to floor because
some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch, do not use any
phone in your building.
• Immediately call your gas supplier from a neighbor’s
phone. Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier, call the fire
department.
C. Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in or
turn by hand, don’t try to repair it. Call a qualified
service technician. Force or attempted repair may
result in fire or explosion.
D. Do not use the gas log set if any part has been under
water. Immediately call a qualified service technician
to inspect the gas log set and to replace any part of
the control system and any gas control which has
been under water.
E. FIREPLACE DAMPER MUST BE FULLY OPENED.