Hatteland Display 23 inch - JH 23T14 MMD - Manual (Page 22)

22
IND100078-17
General Installation Recommendations
Installation
Cables
Use only high quality shielded signal cables and the provided Multifunction Cable.
Cable Entries & Connectors (Marked area) - Illustration only
Bottom View Back View
The cable should generally be kept as short as possible to provide a high quality input/output.The maximum signal
cable length will depend on the signal resolution and frequency, but also on the quality of the signal output from the
computer/radar. Recommended refresh rate is 60Hz. Cables up to 10 meters generally provides good picture quality
even with a 1600x1200 (UXGA) 60Hz signal. In most cases (especially with lower resolutions) even longer cables will
provide a satisfactory result. This should however be tested in advance before making the decision on how far the unit
can be placed from the signal source.
Configuring DC power input housing connector
Note: Only applicable for certain models!
For installations that require DC power input, use the provided
2-pin DC Power Input housing with internal cable screw terminal.
1: Open the housing
2: Unmount the fasteners. (FIG 1)
3: Mount power cables to screw terminal (FIG 2). Note polarity!
4: Secure the cable tightly with fasteners (FIG 3, FIG 1)
5: Close the housing
Note: Please check polarity before connecting any cables
to the screw terminal.
Multifunction Cables
This custom Multifunction Cable with its 160 pins offers a
wide range of additional signal types to be used togther
with the display units. Please refer to the Contents of
Package in this manual to determine which cable and
connector functionality you received.
The cable could also be customized upon customer request for length or to support other signal types and connectors.
Using any other cable/housing design to connect to the display units could result in severe damage to components!
Screw terminal
FIG 1
FIG 2
FIG 3
+ -
+ -
+
-