Hatteland Display 23 inch - JH 23T14 MMD - Manual (Page 27)

Physical Connections
27
IND100133-32
Note: Other Multifunction Cables may include other connections based on a customized solution.
MULTIFUNCTION CONNECTOR:
Mount the 160 PIN cable connector (male) to the 160 PIN connector (female) on the back of the unit as indicated
above. Make sure you fasten it firmly with the provided housing screws to the hex spacers provided on the unit. By
using this cable you can access more signal types than already present by the factory mounted connectors. By factory
standards two cables are available. One for non-touch screen based unit and one for units with factory mounted touch
screen. From this cable you can now have access to the following signal types described below.
3 x COMPOSITE IN/VIDEO IN (if present):
Connect your BNC cable connector (male) to any of the 3 available BNC Connectors (female) on the unit. This will
allow 3 different video signals from i.e. cameras & dvd players to be visible on screen either as full screen video or
Picture-In-Picture/Picture-By-Picture. To activate any of these functionalities, the unit must be configured via the OSD
menus (see own chapter). PAL / NTSC / SECAM VIDEO signal formats supported.
COM RS-232 (if present):
This 9P COM connector provides additional functionality for the unit. The Serial Remote Control features a RS232
interface for controlling internal MMD parameters like brightness. You can access most of the parameters available in
the OSD menu and with special commands control the unit externally.
An in-depth manual is available at http://www.hatteland-display.com/pdflink/inb100018-3.php . This COM can also be
used to upgrade the firmware for the graphic controller inside the unit which is available on request and through
service channels (for qualified personnell only).
COM TOUCH (if present):
This 9P COM connector provides touch screen communication for units that have been equipped with a factory
mounted touch screen. It should be connected to a computer with touch screen drivers installed. See the touch screen
chapter in this manual for more information.