IOTA IIS-125-SM-DR - Manual

IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed, including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1. DO NOT USE OUTDOORS.
2. Do not mount near gas or electric heaters.
3. Do not use this equipment for other than its intended use.
4. The
IIS-125 with Dimming Relay should be mounted securely and in locations and at heights where it will
not readily be subjected to tampering by unauthorized personnel.
5. The IIS-125 with Dimming Relay is not for use in air supply/air return ceilings.
6. The use of accessory equipment and replacement parts not recommended by IOTA Engineering, LLC may
cause an unsafe condition and void the warranty.
7. The AC voltage rating of this equipment is specified on the product label. Do not connect the
IIS-125 with Dimming Relay equipment to any other voltage.
8. Use only the battery part number specified for use with the IIS-125 with Dimming Relay. Failure to do so
may cause an unsafe condition, will void warranty, and result in non-compliance with UL specifications.
9. The IIS-125 with Dimming Relay uses sealed valve regulated lead acid batteries. Batteries can be punc-
tured if not handled properly, therefore use caution when servicing batteries. In the event battery acid
comes in contact with eyes or skin, flush with fresh water and consult a physician immediately.
10. Install in accordance with the National Electrical Code and local regulations.
11. Installation and servicing should be performed by qualified personnel.
12. Electricians and end-users need to ensure product system compatibility before final installation.
SAVE THESE INSTRUCTIONS
IIS-125-SM-DR
IIS-125-CG-DR
125W UNIT INVERTER EQUIPMENT
WITH DIMMING RELAY
THIS UNIT CONTAINS A
RECHARGEABLE VALVE-REGULATED
LEAD ACID BATTERY. PLEASE
RECYCLE OR DISPOSE OF
PROPERLY.
INSTRUCTION MANUAL
P.O. BOX 11846 TUCSON, AZ 85734
(520) 294-3292 • FAX (520) 741-2837
www.iotaengineering.com