Product overview, Plm+ series quick start guide rev 1.0.0, Input connectors – Lab.gruppen PLM 20K44 User Manual

Page 13

Advertising
background image

11. Product overview

PLM+ SERIES Quick Start Guide rev 1.0.0

13

11.2. Rear panel

1

2

3

4

INPUT 1

INPUT 2

INPUT 3

AES/EBU

INPUT 1-2

INPUT 3-4

SEC

PRIM

Must be grounded/earthed

Made in Sweden

PIN 1: SCRN 2: POS 3: NEG

ANALOG WITH

I

SO-

F

LOAT

TM

50-60Hz

100-240V 2400-2950W

Ser. N:o

Removed!

CH

2

CH

1

CH

4

CH

3

SPEAKER OUTPUTS

CLASS 3 WIRING

BRIDGE

BRIDGE

INPUT 4

SWITCHED 00/ 000 Base-TX

1 1

1Gbps

1Gbps

LINK

ACT

LINK

ACT

PLM 2K44

1

1+/- CH 1+/-
2+/- CH 2+/-

1+/- CH 1+/-
2+/- CH 2+/-

3+/- CH 3+/-
4+/- CH 4+/-

1+/- CH 3+/-
2+/- CH 4+/-

CLASS 3

WIRING

BRIDGE CH 1 & 2:

1+:+

2- : -

BRIDGE CH 3 & 4: 1+ : +, 2- : -

SPEAKER OUTPUTS

INPUT 1

INPUT 2

INPUT 3

AES/EBU

INPUT 1-2

INPUT 3-4

SEC

PRIM

Must be grounded/earthed

Made in Sweden

PIN 1: SCRN 2: POS 3: NEG

ANALOG WITH

I

SO-

F

LOAT

TM

50-60Hz

100-240V 2400-2950W

INPUT 4

SWITCHED 00/ 000 Base-TX

1 1

1Gbps

1Gbps

LINK

ACT

LINK

ACT

PLM 2K44

1

7

5

6

Input Connectors

1

Analog Inputs – Four analog inputs are available on standard XLR-3F connectors, electronically balanced and

featuring Lake Iso-Float circuitry. Impedance is 20 kohms; maximum input level is +26 dBu.

2

AES3 Inputs – Two latching XLR-3F connectors accept four channels of AES3 digital audio. Input impedance

is 110 ohms; ensure that 110 ohm digital audio cables are used.

Output Connectors

Your device will be equipped with one of the two output connector options. Both options allow for Bridge Mode
operation, which is activated in the Lake Controller software. Please refer to the Lake Controller Operation Manual
for more information.

3

Binding Posts – Power outputs are available on four separate pairs of fully enclosed binding posts.

4

speakON connectors – Power outputs are available simultaneously on a single 8-pole connector and on two

4-pole connectors. The four-pole connectors carry outputs for channels 1&2 and 3&4 respectively.

Ethernet and Power Connectors

5

Primary Network Connector – The primary Neutrik RJ45 etherCON® connection provides integration into

an Ethernet control network which may include other Lake Processors and the Lake Controller software. Network
connection permits full control of all functions along with real-time metering from a remote position. This device
supports the Dante audio networking protocol for multichannel, high-definition digital audio over the same Ethernet
connection.

speakON version

Advertising
This manual is related to the following products: