Labconco Class I Enclosure Models 3980423 User Manual

Page 14

Advertising
background image

Chapter 3: Getting Started

Product Service 1-800-522-7658

10

10


Work Surface and HEPA Filtered Enclosure Installation

1. Level the base cabinets and the work surface. Work surface should be

placed flush with the front of the base cabinet as shown in Figure 3-1.

2. Position the work surface in its intended location and with the front of the

work surface towards you. (Rear mounting holes are located close to the
rear edge.)

3. Secure the work surface to the base cabinet with a structural adhesive or

silicone sealant.

4. Insert the supplied mounting screws in the four holes. Allow a minimum

of 1/8" clearance under the head of the screw for positioning the enclosure.

5. Place the enclosure on the work surface and slide the rear flange and front

air foil flanges under the mounting screw heads.

6. Tighten the four screws to complete the installation.

Advertising
This manual is related to the following products:

Class I Enclosure Models 3980421, Class I Enclosure Models 3980403, Class I Enclosure Models 3980401, Class I Enclosure Models 3980323, Class I Enclosure Models 3980321, Class I Enclosure Models 3980303, Class I Enclosure Models 3980301, Class I Enclosure Models 3980223, Class I Enclosure Models 3980221, Class I Enclosure Models 3980203, Class I Enclosure Models 3980201, HEPA Filtered Enclosure Models 3980422, HEPA Filtered Enclosure Models 3980420, HEPA Filtered Enclosure Models 3980402, HEPA Filtered Enclosure Models 3980400, HEPA Filtered Enclosure Models 3980322, HEPA Filtered Enclosure Models 3980320, HEPA Filtered Enclosure Models 3980302, HEPA Filtered Enclosure Models 3980300, HEPA Filtered Enclosure Models 3980222, HEPA Filtered Enclosure Models 3980220, HEPA Filtered Enclosure Models 3980202, HEPA Filtered Enclosure Models 3980200

Popular Brands
Popular manuals