Labconco Purifie Horizontal Clean Benches 3970424 - Manual (Page 14)

Chapter 3: Getting Started
Product Service 1-800-522-7658 10
10
Work Surface Specifications
The work surface should be smooth, rigid and durable, such as a chemical-resistant
epoxy resin. The surface should be non-porous and resistant to the materials used
in conjunction with the Purifier Vertical Clean Bench. The work surface should
also contain a dished recessed area for containing primary spills.
Vertical Clean Bench Work Surface
1. Level the base cabinet or stand and the work surface. See Figure 3-1.
2. Position the work surface in its intended location and with the front of the
work surface towards you. (Rear mounting holes are located close to the
rear edge.)
3. Secure the work surface to the base cabinet or stand with a structural
adhesive or silicone sealant.
4. Insert the supplied mounting screws in the four holes. Allow a minimum
of 1/8" clearance under the head of the screw for positioning the Clean
Bench.
5. Place the Clean Bench on the work surface and slide the rear flange and
front air foil flanges under the mounting screw heads.
6. Tighten the four screws to complete the installation.