Labconco Purifie Horizontal Clean Benches 3970424 - Manual (Page 7)

Chapter 1: Introduction
Product Service 1-800-522-7658 3
Chapter 4: Performance Features and Safety Precautions explains how the
Purifier Vertical Clean Bench operates and the appropriate precautions you should
take when using it.
Chapter 5: Appropriate Applications for your Vertical Clean Bench discusses the
basic operation of how to prepare, use and shut down your Clean Bench.
Chapter 6: Maintaining Your Vertical Clean Bench explains how to perform
routine maintenance on the Clean Bench.
Chapter 7: Accessorizing Your Vertical Clean Bench explains acceptable
modifications to the Clean Bench or how to add accessories.
Chapter 8: Troubleshooting contains a table of problems you may encounter while
using the Clean Bench including probable causes and suggested corrective actions.
Appendix A: Components and Replacement Parts contains labeled diagrams of all
of the components of the Clean Benches.
Appendix B: Dimensions contains comprehensive diagrams showing all of the
dimensions for the Clean Benches.
Appendix C: Vertical Clean Bench Specifications contains the electrical
requirements for clean benches. Wiring diagrams are also included.
Appendix D: References lists the various resources available that address clean
rooms and Clean Benches.
Typographical Conventions
Recognizing the following typographical conventions will help you understand and
use this manual:

Book, chapter, and section titles are shown in italic type (e.g., Chapter 3:
Getting Started).

Steps required to perform a task are presented in a numbered format.

Comments located in the margins provide suggestions, reminders, and
references.

Critical information is presented in boldface type in paragraphs that are
preceded by the exclamation icon. Failure to comply with the information
following an exclamation icon may result in injury to the user or permanent
damage to the enclosure.

Critical information is presented in boldface type in paragraphs that are
preceded by the wrench icon. Only a trained certifier or contractor should only
perform these operations. Failure to comply with the information following a
wrench icon may result in injury to the user or permanent damage to your
Clean Bench.
!