Laerdal Twelve Lead Task Trainer - Manual (Page 8)

Waveform mode –
While in waveform mode, the unit will display the
current mode and pacing status on the top line and the
current waveform # and name on the bottom line. The
unit will output 12 lead waveform data for the currently
selected waveform. Waveform mode also allows
waveform pacing.
To enable pacing:
Press the ‘Pace’ button while in waveform mode. When
waveform pacing is enabled, the top line of the LCD will
display the letter ‘Y.’ This is located under the ‘PACE’
text on the remote. The letter ‘N’ will be displayed when
pacing is not enabled. When enabled (‘Y’), the manikin
can receive pacing output from a pacer unit. Once the
pacer unit output reaches approximately 80 – 90 mA, the
AST-12 allows electrical capture.
Pacing enabled – ‘Y’
Pacing not enabled – ‘N’
Program mode:
To enter program mode, press ‘Prog>’ button. This is
where all scenario program editing is done. The
unit allows for storage of up to nine (9) scenarios having
nine (9) steps each. During editing, the user may use any
of the digits on the numeric keypad or the ‘
+ ’ and ‘ - ’
buttons.
While in program mode, the unit will display on the top
line:
• Current mode
• Current scenario #
• Current scenario step number
• Defib step advance
• Step timer status
The bottom line will display the waveform # and name
for the indicated scenario and step.
Laerdal 8