Lingenfelter L320030709 Lingenfelter CTS-V Intercooler Radiator Kit 2009-13 v1.1 - Manual (Page 15)

Page 14
42. Route the hose from the inlet of the
pump over to the hose joiner (in the hose
assembly you connected to the intercooler
radiator outlet in an earlier step). Determine
the correct length of hose needed and then
mark the hose in the correct location as
shown. Cut the hose in the marked location.
You should need to remove roughly 1 foot of
hose.
43. Install two pieces of the supplied heat shrink
tubing over the hose. Then slide one of the
27.1 mm (PN: 52545K75) Oetiker clamps
over the hose and then slide the hose
(coming from the intercooler pump) over
the hose joiner assembly. Once you have
the hose assembly in place and clocked
correctly, check to make sure the hoses are
not bent or kinked. Tighten the clamps using
Oetiker pliers.
44. Slide the the heat shrink tubing to each end
of the hose assembly and then install the 1”
mesh loom (PN: TFX-F6N1.00BK) over the
inlet hose and cut to length.
41. Locate the supplied 3/4” hose with a 90
degree bend (PN: 9820). Using hose clamp
pliers to release the tension on the clamp,
slide one of the stock constant tension hose
clamps onto the end of the hose closest to
the 90 degree bend. Connect this end to the
pump inlet and then use hose clamp pliers
to secure the hose with the hose clamp.