Lingenfelter L320030709 Lingenfelter CTS-V Intercooler Radiator Kit 2009-13 v1.1 - Manual (Page 23)

Page 22
73. Remove the plastic plugs from the supplied
power steering heat exchanger. Apply a
light coating of oil or o-ring safe assembly
lubricant to the threads of the 3/8” push
to lock 90 degree fittings (PN: SET22-
M22PL06-90). Install the 90 degree hose
end fittings into the power steering cooler as
shown.
74. Slide the supplied 17mm Oetiker clamps
(PN: 52545K55) over the 3/8 hoses from
Step 72 and then push the hoses (PN:
H1937) onto the barbed ends of the fittings.
Using Oetiker pliers, crimp the clamps over
the hoses to secure them onto the fittings.
Install a piece of the supplied heat shrink
tube over the hose.
75. Cut the supplied 3/4” mesh loom into two
sections 2 feet long (each). Then slide each
of the two sections onto the power steering
hoses attached to the cooler.
Angle both of the fittings and hoses inwards
(towards each other). Once the fittings are
clocked properly use a 1-1/16” inch (27mm)
wrench to tighten the fittings. Tighten to 30
lb-ft (40 Nm).
76. Place the power steering cooler back
into place on the impact bar. As indicated
previously, it is recommended to have the
hoses point inwards towards each other.
This will help with the packaging of the
hoses. Tighten the screws in place using a
3/8” socket and wrench . Torque to 5 lb-ft (7
Nm).