Lingenfelter L460260704 Lingenfelter CAN to Analog Gauge & Relay Output Module CAN2 v1.0 - Manual (Page 27)

Hardware Install 27
© 2014 Lingenfelter Performance Engineering
2.8.4 Analog Signal Type Output
When sending an analog sensor signal to an external module you would wire the CAN2-002 module to
the external device as follows:
Make sure the circuit board DIP switch is set to Internal
Connect the signal wire (green tracer) for the output channel in question on the CAN2 module to the
analog signal input on your external device.
You may choose to wire the ground wire (black tracer) for the output channel in question on the CAN2
module to the analog signal ground on your external device. This may improve the accuracy of the
signal by reducing the likelihood of a ground offset existing between the two device signals.
Do not connect anything to the power wire (red tracer) on the CAN2 module.