LINK Systems 5100-8 Tonnage & Analog Signal Monitor - Manual (Page 18)

Doc #: L-802-1110 Page 16 Rev. 02
CHANGE VIEW
Softkey This softkey is used to change the tonnage view between peak, data window 1,
data window 2, data window 3, and data window 4 as explained in section
3.2.1 on page 18.
LOW LIMITS
ON/OFF Softkey This softkey toggles the low limits between ON and OFF. See section 3.2.2
on page 19 for more information on limits.
BYPASS ON/OFF
Softkey This softkey turns the tonnage monitor bypass mode ON and OFF. See
section 3.2.4 on page 22 for more information on bypassing the tonnage
monitor.
REVERSE
TONNAGE Softkey This softkey changes the tonnages displayed to reverse peak tonnages (see
Figure 7). This key is only present when viewing forward peak tonnage. See
section 3.2.1 on page 18 for more information.
RESET FAULT
Softkey This softkey is used to reset tonnage alarms and fault conditions. See section
3.2.5.7 on page 24 and section 3.2.6.3 on page 26 for more information on
resetting alarm and error conditions.
AUTO-SETUP
Softkey This softkey is used to initiate an auto-setup sequence. See section 3.2.2.4 on
page 20 for more information.
GRAPH Softkey This softkey brings up the tonnage graph screen. See section 3.5 on page 30
for information about the graph screen.
BYPASS SETUP
Softkey This softkey brings up the bypass setup screen. See section 3.4 on page 29 for
more information on this screen.
DIAGNOS Softkey This softkey brings up the tonnage monitor diagnostics screen. See section
3.3 on page 27 for more information on this screen.
CONFIGURE Softkey This softkey brings up the tonnage monitor configuration screen. Note that it
is only present when the RUN/PROG key switch is in the PROG position. In
addition, the system configuration code is required to gain access to these
screens. See section 4.3 on page 43 for more information on this screen.