4 the tonnage monitor machine settings screen, 1 units, The tonnage monitor machine settings screen – LINK Systems 5100-8 Tonnage & Analog Signal Monitor User Manual

Page 45: Figure 17: tonnage monitor machine settings screen, 3 the tonnage monitor configuration screen, Figure 16: tonnage configuration screen

Advertising
background image



Doc

#:

L-802-1110 Page

43 Rev.

02

Stroke

Mode

Single Stroke

Drive

Speed

Stroke

Speed

SPM

SPM

0
0

Order

Counter

Current Status

Counter OFF

EXIT

0

0

Program/Run Switch

TOP

Tonnage
Monitor

Tonnage Monitor Channels:

4

Tonnage Monitor Device Configuration

CHANGE
SETTING

Stroke

Mode

Single Stroke

Drive

Speed

Stroke

Speed

SPM

SPM

0
0

Order

Counter

Current Status

Counter OFF

EXIT

0

0

Program/Run Switch

TOP

Tonnage
Monitor

Tonnage Monitor Channels:

4

Tonnage Monitor Device Configuration

CHANGE
SETTING

Figure 15: Tonnage Monitor Device Configuration Screen


Use the CHANGE SETTING key to select the number of channels for the tonnage monitor. Once the
number of channels is set, the rest of the tonnage monitor settings are found in the configuration screens
reached from the main tonnage monitor screen.

4.3 The Tonnage Monitor Configuration Screen

The configuration screens of the
tonnage monitor module are
accessed by selecting the
CONFIGURE softkey in the Main
Tonnage Monitor Screen with the
RUN/PROG keyed selector switch
in the PROG position. The operator
terminal will request entry of the
configuration access code and upon
correct entry will provide the
configuration menu shown in Figure
16. This screen provid
es access to
the individual configuration screens
discussed in the following sections.
Note that the tonnage monitor
screen will not be available until the
tonnage monitor is turned on in the
Device Config screen as explained in section 4.1
.

Stroke

Mode

Single Stroke

Drive

Speed

Stroke

Speed

SPM

SPM

0
0

Order

Counter

Current Status

Counter OFF

EXIT

0

0

Program/Run Switch

TOP

Tonnage Monitor Machine Settings

SELECT

SELECT

SELECT

Tonnage Monitor Calibration

Machine Rating Derate Table

Stroke

Mode

Single Stroke

Drive

Speed

Stroke

Speed

SPM

SPM

0
0

Order

Counter

Current Status

Counter OFF

EXIT

0

0

Program/Run Switch

TOP

Tonnage Monitor Machine Settings

SELECT

SELECT

SELECT

Tonnage Monitor Calibration

Machine Rating Derate Table

Figure 16: Tonnage Configuration Screen

Advertising