Luxul XAP-1040 - Manual (Page 12)

User Guide
12 © Copyright 2014 Luxul. All rights reserved. Trademarks & Registered Trademarks are property of respective holders.
Reset Button:
The Reset button is used to clear the current settings of the XAP-1040 and restore
factory default settings.
To Restore the Default Settings: With the XAP-1040 powered on, press and hold
the Reset button for 15 seconds. When all the LEDs except the power LED turn off,
release the reset button. The power LED will stay solid. The XAP-1040 will be set to
factory defaults.
CAUTION: Pressing and holding the Reset button will remove any
custom confi gurations done to the XAP-1040.
4.5 Environmental Requirements

Ethernet cable to provide Power and Data to the XAP-1040.

A computer supporting TCP/IP and equipped with a Web browser. Supported
Web browser versions include Microsoft IE 8+, Firefox 4+, Safari 5+, Google
Chrome 5+. The Web browser is used to confi gure the XAP-1040.

The XAP-1040 uses 36-57VDC power. The POE injector power supply requires AC
100V ~ 240V, 50Hz ~ 60Hz.

Temperature of the operating environment: -4F~131F (-20C to 55C). Be sure to
place the access point away from heat generating devices.

Humidity of the operating environment: 5%-95% non-condensing. Do not place
the access point in an extremely dirty or damp location.

Keep the access point away from strong electromagnetic fi elds (i.e. Air
Conditioner compressors, fl uorescent light ballasts, CRT monitors/televisions,
etc.), and free from vibration, dust and direct sun light.
4.6 Hardware Installation
4.6.1 Access Point Placement
This XAP-1040 implements Luxul’s Circular Polarized directional antenna technol-
ogy. For maximum effi ciency, it should be aimed towards the area to which you
would like to provide coverage. With this in mind, the ideal placement option is
usually on an outside wall or pole pointed into the coverage area.