Luxul XAP-1040 - Manual (Page 14)

User Guide
14 © Copyright 2014 Luxul. All rights reserved. Trademarks & Registered Trademarks are property of respective holders.
RJ-45 Connector Gland assembly
NOTE: Category-5, super Category-5 or Category-6 unshielded twisted pair
(CAT5/CAT5e/CAT6 UTP) cables should be used. For best results, it
is recommended that CAT5e or CAT6 shielded twisted pair be used
to ensure stable data transmission at highest data rates.
Once the RJ45 Connector Gland has been assembled and the Ethernet Cable has
been terminated, the cable can now be plugged into the XAP-1040. You can now at-
tach the RJ-45 Connector Gland by placing it over the cable connector and turning
it clockwise until it is fi rmly secured. At this time, also tighten the gland around the
cable by turning it clockwise and thus creating a water-tight seal.
4.6.4 Connecting to the Power Source
The XAP-1040 is POE ready and supports Legacy (48v 1a), 802.3af, and 802.3at POE
injectors. A POE injector kit, including power supply and noise suppressor are
included with the device. To apply power, simply connect the opposite end of the
Ethernet cable to which the access point is already connected to the provided POE
injector or other POE switch or injector. An Ethernet cable length of up to 300 feet
can be used. DO NOT yet apply power to the POE injector or switch.
NOTE: To ensure FCC compliance and minimize high frequency noise, a
Ferrite Noise Suppresser is included with the POE injector kit. It
should be placed on the Ethernet cable at or near the connector
on the end of the Ethernet cable that plugs into the POE device.
To install it, simply unsnap the plastic fasteners, place it on the
Ethernet cable as demonstrated below and re-snap the plastic
fasteners to secure it in place.
4.6.5 Connecting to the Internet Source
NOTE: If your Internet source (Router or Switch) is a POE enabled device
and connected via POE, it can be plugged directly into the access
point without the need to run a separate POE injector.