Datalogic Scanning Formula - Manual (Page 43)

USE AND FUNCTIONING
3
3.3 DELETING AND LOADING THE APPLICATION
PROGRAM
This procedure allows deleting application programs developed with DS for
Formula™. If you want to delete programs provided or developed by
EasyGen™, refer to chapter 6 of the EasyGen™ manual.
NOTE
The following procedure causes data to be deleted even if not
completed.
To delete the application program, follow the instructions below:
1- Press the <SCAN> key and the ON/OFF power key simultaneously; the
display will show:
PROGRAM
ERASE?
Up = No Down = Yes
NOTE
If you do not want to delete the application program, press the
{▲} key or wait about 25 seconds.
2- To continue with the deletion, press the ▼ key; after a few seconds, the
display will show:
Boot from:
1. USB
2. MMC
3. Serial
Select one of the boot mode options by pressing the following keypad buttons:
-
Press 1 to select download via USB cable connection.
- Press 2 to select download via MMC/SD card.
- Press 3 to select download via serial cable connection.
23