Datalogic Scanning DS2200 - Manual

DS2200 QUICK GUIDE
DS2200
General View: Laser Safety:
The scanner is classified as a Class 2 laser product
according to EN 60825-1 regulations and as a Class
II laser product according to CDRH regulations.
For installation, use and maintenance it is not
necessary to open the device.
There is a safety device which allows the laser to be
switched on only if the motor is rotating above the
threshold for its correct scanning speed.
The laser beam can be switched off through a
software command (see also the WinHost Help On
Line).
Figure A Warning and device class labels
1
2
3
4
8
7
6
5 Barcode Image Input Window
Laser Beam Output Window
Power On LED
Good Read LED
Ext Trig LED
TX Data LED
Mounting Holes
Laser Warning and
Device Class Label
The laser diode used in this device is classified as a
class 3B laser product according to EN 60825-1
regulations and as a Class IIIb laser product
according to CDRH regulations. As it is not possible
to apply a classification label on the laser diode
used in this device, the following label is
reproduced below.
For further details on product installation, see the
complete Installation Manual.
DS2200 can be configured through the WinHost
Windows-based software program available on the
installation CD-ROM.
For configuration it is necessary to create a cable
connecting the scanner to the PC as indicated in
the “How To Build A Simple Interface Test Cable”
section of this guide.
Power Supply:
- This product is intended to be installed by
Qualified Personnel only.
- DS2200 All Models:
This device is intended to be supplied either by a
UL Listed NEC Class 2 power source, or a UL listed
ITE Limited Power Source (LPS), rated 5Vdc,
minimum 0.4A.
LASER LIGHT
AVOID EXPOSURE TO BEAM
CLASS 3B LASER PRODUCT
MAX. OUTPUT RADIATION 7 mW
EMITTED WAVE LENGTH 630~680 nm
TO EN 60825-1 (2001)
Laser diode class label
Any violation of the optic parts in particular can
cause radiation up to the maximum level of the
laser diode (7 mW at 630 to 680 nm).
WEEE Compliance:
CAUTION-CLASS 3B LASER LIGHT
WHEN OPEN AVOID EXPOSURE TO BEAM
This product conforms to the applicable
requirements of 21CFR1040 at the date of
manufacture.
DATALOGIC S.p.A. Via Candini, 2
40012 Calderara di Reno - Bologna - Italy
LASER LIGHT
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
MAX. OUTPUT RADIATION 1 mW
EMITTED WAVELENGTH 630~680 nm
TO EN 60825-1:2001
2
1
6
5
4
3
7
8