Datalogic Scanning DS2200 - Manual (Page 3)

DS2200 QUICK GUIDE
3
Electrical Connections:
DS2200 is equipped with a cable terminated by a 25-pin female D-sub connector for connection with the power
supply and input/output signals.
CAUTION
Do not connect GND and SGND to different (external) ground references. GND and SGND
are internally connected through filtering circuitry which can be permanently damaged if
subjected to voltage drops over 0.8 Vdc.
The details of the connector pins are indicated in the following table:
25-pin D-sub female connector pinout
Pin Name Function
9, 13 VS Power supply input voltage +
25 GND Power supply input voltage -
1 CHASSIS Chassis ground
19 EXT TRIG- External Trigger -
10, 12, 22 I/O REF I/O Reference
8 OUT1+ Output 1+
11 OUT2+ Output 2+
2 TXAUX TX RS232 Aux. Interface
3 RXAUX RX RS232 Aux. Interface
4 RTX485- RTX- RS485 Main Interface
5 RTX485+ RTX+ RS485 Main Interface
7 SGND Signal Ground
16 NGND Internal Use – for Service only
17 FPE Internal Use – for Service only
6, 14, 15, 18, 20, 21, 23, 24 NC No Connect
25-pin female connector
Mechanical Installation:
mm
inch
8.
5
0.
33
50
1.
97
40
1.57
8.2*
0.32
28
1.10
M 2.5 n° 3
33.5
1.32
40
.5
1.
59
3.
25
0.
18
2.7 n° 4
48.5
40.5
2 x
45
°
n°
4
30
2
10
16.
8
6.
7
6.
7
2
25
3.2
14
3.
2
15
26.5
90°
2.
5 x 45
° n
°2
mm
* The quote refers to the scan line