RODE Microphones NT1 - Manual (Page 8)

8
Connect all cables before supplying phantom power to the
microphone and never remove the microphone cable while the
power is connected.
The NT1 requires 48V DC (P48) or 24V DC (P24) phantom power.
If the mixer or preamp does not contain this phantom power
requirement, then an external phantom power supply is needed.
Some phantom power supplies do not supply the voltage at which
they are rated. If the required voltage is not supplied, the dynamic
range and general performance of the microphone will be reduced.
We strongly suggest the use of a reputable high quality power
supply. Damage caused by a faulty power supply is not covered
under warranty.
Powering the NT1
148-950-1-13_NT1_multilingual_manual.indd 8 148-950-1-13_NT1_multilingual_manual.indd 8 13/08/2013 2:51:42 PM 13/08/2013 2:51:42 PM