SpectraCal VideoForge HDMI - Manual (Page 5)

17544 Midvale Ave. N. Ste 100, Shoreline, WA 98133 USA
Corporate: +1 206 420 7514 | Tech Support: +1 206 457 8949 | www.spectracal.com
VideoForge HDMI
CalMAN Setup Guide
The AVFoundry VideoForge HDMI Digital Video Generator can be automatically controlled by
the CalMAN Display Calibration Software.
Required CalMAN version:

5.2.1 or later

VideoForge HDMI version 2.1 requires CalMAN version 5.4.1 or later
Recommended CalMAN Workflows:

All available measurement and calibration workflows
Required VideoForge HDMI Firmware:

All firmware versions are acceptable
VideoForge HDMI Control Connection:

Ethernet cable (straight-through or crossover cable)

Wi-Fi connection
CalMAN Connection Procedure
Connect with either a direct Ethernet cable or over a local area network:
1. Connect the VideoForge directly to a host computer with an Ethernet cable (straight-
through or crossover cable).
2. On the CalMAN Source Settings tab, click “Find Source,” then select “AV Foundry;
VideoForge II / HDMI (Ethernet @9021).”