SpectraCal VideoForge HDMI User Manual
Page 6
17544 Midvale Ave. N. Ste 100, Shoreline, WA 98133 USA
Corporate: +1 206 420 7514 | Tech Support: +1 206 457 8949
3. On the Source connect page, select the “VideoForge-xxxx” listing (with xxxx being the
four characters listed at the end of the Power label on the bottom of the VideoForge
case).
4. Click Connect on the Source connect dialog.
Connect through the VideoForge Wi-Fi adapter:
1. Connect the supplied Wi-Fi adapter to the lower USB jack on the VideoForge rear panel.
NOTE: A wired Ethernet connection to the VideoForge HDMI disables the unit’s Wi-Fi
interface.
2. On a host computer within Wi-Fi range, select the wireless connection labeled
“VideoForge-xxxx” with xxxx being the four characters listed at the end of the Power
label on the bottom of the VideoForge case.
3. Enter the wireless password “VideoForge”
4. On the CalMAN Source Settings tab, click “Find Source,” then select “AV Foundry;
VideoForge II / HDMI (Ethernet @9021).”
5. On the Source connect page, type “172.24.24.20” for the IP Address.
6. Click Connect on the Source connect dialog.
CalMAN Source Settings Tab
Triplet Support
The VideoForge HDMI provides full RGB triplet support to provide test patterns that are
compatible with 3D cube LUT calibration.
Window Size
Window 2%