SpectraCal Fujifilm IS-Mini - Manual (Page 2)

3528 Bagley Ave. N. Seattle, WA 98103 USA
Corporate: +1 206 420 7514 | Tech Support: +1 206 457 8949 | www.spectracal.com
4. On the RGB Adjust page, under the RGB Adjust Levels selection, select “2 Point 30, 100%.”
Click Read Continuous and adjust the display’s RGB Gain controls for RGB balance at 100%.
Adjust the display’s RGB Offset/Bias controls (if provided) for RGB balance at 30%.
This step is for manually optimizing the display’s white balance, prior to automatic LUT
calibration.
5. Skip the 1D Ramp LUT page (a 1D LUT does not need to be created).
1. On the 3D Cube LUT page, click the AutoCal (rotating arrows) button at the right end of
the meter action buttons. The AutoCal Setup dialog then appears (see below).
2. Under File Path, select the desired directory path and provide a name for the LUT file
that CalMAN will create (e.g. monitor ID and date).
3. Under Calibration Type, select the desired type of 3D LUT calibration process.

IR Profile (time based): Creates the best quality display calibration 3D LUT
possible in the selected period of time. You select how much display quality you
have time for, from 30 minutes to maximum display quality (6,000 points max).
Uses Intelligent Resolution Profiling to search out the most nonlinear color
space areas and correct those first.

IR Profile (point based): Creates the best quality display calibration 3D LUT
possible with the selected number of measurement points (1,000 - 10,000