SpectraCal Fujifilm IS-Mini User Manual
Page 3
3528 Bagley Ave. N. Seattle, WA 98103 USA
Corporate: +1 206 420 7514 | Tech Support: +1 206 457 8949 |
points). Uses Intelligent Resolution Profiling to search out the most nonlinear
color space areas and correct those first.
Lightning LUT: Creates a display calibration 3D LUT in five minutes or less.
Produces a very high quality result on professional displays with moderate
linearity. Displays with significant nonlinearity may produce marginal results.
4. Under Video Range, select “SMPTE (16-235)” if you are calibrating a video display
that
clips signal values above reference white.
5. Click OK.
When the AutoCal process completes, CalMAN automatically loads the optimized 26x26x26 LUT
calibration data into the IS-mini.
DONE: IS-mini 3D LUT calibration and setup is complete.
CalMAN 3D LUT Display Calibration File Creation for IS-mini
CalMAN can also create a 3D LUT display calibration file for the IS-mini without immediately loading the
file into the IS-mini. The IS-mini does not need to be available during this display calibration and file
creation process. The file created will be a .3dl file with the proper IS-mini data format for later loading
into the IS-mini with CalMAN (as detailed below).
To create a 3D LUT display calibration file for the IS-mini with CalMAN:
1. In the CalMAN main menu, select Open Workflow Template, then select the ‘Color Cube (3D
LUT)’ workflow.
2. On the CalMAN Display Control tab, connect to the SpectraCal Cube Generator as a Display
Control device.
3. On the Display Control tab, under ‘File Format,’ select ‘Fujifilm IS-mini (.3dl).’
4. On the Display Control tab, under ‘File Path,’ select your desired destination for the .3dl LUT file.
5. On the CalMAN Source Settings tab, select your desired test pattern source for display
calibration (this can be the Fujifilm IS-mini, if available).
6. Follow the display calibration instructions in the ‘CalMAN 3D LUT Display Calibration’ section
above.
Done: Upon completion of the AutoCal 3D LUT calibration process, CalMAN automatically writes a .3dl
file, containing color cube display calibration data, to your selected file destination. This display
calibration file can be later loaded to an IS-mini, using the procedure in the ‘CalMAN 3D LUT Load to IS-
mini’ section below.
CalMAN 3D LUT Load to IS-mini
CalMAN can load a properly formatted 3D LUT file into the IS-mini. The LUT needs to be a .3dl LUT file
with a bit depth of 10 bits and 26x26x26 data points, with the data points at the following bit levels:
0,40,81,122,163,204,245,286,327,368,409,450,491,531,572,613,654,695,736,777,818,859,900,941,982,
1023.
This .3dl LUT file can be a display calibration LUT created with the CalMAN Cube Generator function (as
detailed above). Or, it can be a creative (look) LUT created by any other application (with the proper