SpectraCal Panasonic DT50 User Manual
Page 2
1. Connect both the display and the CalMAN computer to a DHCP capable network router with
straight through Ethernet cables.
2. In the Panasonic Setup menu, select “Network Settings.”
3. Under “Network Connection,” select “Ethernet cable.”
4. Under “IP address/DNS settings,” set “IP Setting Mode” to “Automatic.”
5. Under “IP address/DNS settings,” record the display’s IP address.
To connect the calibration computer to a VT30/GT30/DT30/VT50/GT50/WT50/DT50 through a wireless
(Wi-Fi) network (VT30/DT30/D30 requires supplied Wi-Fi dongle):
1. Connect the CalMAN computer to the same wireless network to which the display is connected
(may require a security password).
2. In the Panasonic Setup menu, select “Network Settings.”
3. Under “Network Connection,” select “Wireless (Wi-Fi).”
4. Under “IP address/DNS settings,” set “IP Setting Mode” to “Automatic.”
5. Under “IP address/DNS settings,” record the display’s IP address.
CalMAN Connection Procedure
To connect CalMAN to the Panasonic display and enable the ISFccc mode:
1. On the Panasonic display, open the “Picture” menu.
a. Under “Viewing Mode,” select “Lock Settings.”
b. Enter “i085” (the ‘i’ button is just under the Power button on the remote).
c. Arrow down to “ISFccc Network” and press OK on the remote.
d. At this point, the display will read “Waiting for Connection.”
2. In CalMAN, under “Find Display,” select “Panasonic – VT30/GT/DT VT50/GT/DT/WT (EU/UK
Models).”
a. Under Connection Method, select “Socket.”
b. Under Socket Connection, enter the IP Address you previously recorded.
c. Click Connect on the display connect panel.
3. In CalMAN, on the Display Control panel.
a. Under Display Mode Selection, select “ISF Day” or “ISF Night.”
b. Under Active Grayscale Points, select 2 points or select 10 points (VT models only).
Panasonic DDC Picture Controls:
Panasonic Picture controls are available within the CalMAN software, allowing you to make display
adjustments in the software, rather than using the display’s remote control. On those calibration
workflow steps where you need to make a manual display adjustment (e.g. Brightness, Contrast,
etc.), you can open the CalMAN DDC panel to make those adjustments from the CalMAN screen.
Panasonic Display Calibration:
Setup/Advanced (isfccc) – Select ON to enable the Professional modes.
Picture/Viewing Mode – Select PROFESSIONAL 1 or PROFESSIONAL 2.