SpectraCal Panasonic 2011-2012 WT50 User Manual
Page 2
To connect the calibration computer to a VT30/DT30/D30/VT50/WT50 with a direct Ethernet cable:
1. Connect both the display and the CalMAN computer to a DHCP capable network router with
straight through Ethernet cables.
2. In the Panasonic Setup menu, select “Network Settings.”
3. Under “Network Connection,” select “Ethernet cable.”
4. Under “IP address/DNS settings,” set “IP Setting Mode” to “Automatic.”
5. Under “IP address/DNS settings,” record the display’s IP address.
To connect the calibration computer to a VT30/DT30/D30/VT50/WT50 through a wireless (Wi-Fi___33)
network (VT30/DT30/D30 requires supplied Wi-Fi___33 dongle):
1. Connect the CalMAN computer to the same wireless network to which the display is connected
(may require a security password).
2. In the Panasonic Setup menu, select “Network Settings.”
3. Under “Network Connection,” select “Wireless (Wi-Fi).”
4. Under “IP address/DNS settings,” set “IP Setting Mode” to “Automatic.”
5. Under “IP address/DNS settings,” record the display’s IP address.
CalMAN Connection Procedure
To connect CalMAN to the Panasonic display and enable the ISFccc mode:
1. On the Panasonic display, open the “Picture” menu.
a. Select the “Custom” Picture Mode.
b. Highlight the “Pro Settings” menu item.
c. Press and hold the RED key on the Panasonic remote for 4+ seconds until ‘Waiting for
Connection’ is shown on the display.
2. In CalMAN, under Find Display, select “Panasonic – VT30/DT/D VT50/WT (US/NA Models).”
Serial Connection
a. Under Connection Method, select COMM.
b. Under Serial Connection, select the com port connected to the display.
c. Click Connect on the display connect panel.
Ethernet Connection
a. Under Connection Method, select Socket.
b. Under Socket Connection, enter the IP Address you previously recorded.
c. Click Connect on the display connect panel.
3. In CalMAN, on the Display Control panel.
a. Under Display Mode Selection, select ISF Day or ISF Night.
b. Under Active Grayscale Points, select 2 points or select 10 points (VT models only).
Panasonic DDC Picture Controls:
Panasonic Picture controls are available within the CalMAN software, allowing you to make display
adjustments in the software, rather than using the display’s remote control. On those calibration