SpectraCal Panasonic 2011-2012 WT50 - Manual (Page 3)

workflow steps where you need to make a manual display adjustment (e.g. Brightness, Contrast,
etc.), you can open the CalMAN DDC panel to make those adjustments from the CalMAN screen.
Panasonic Display Calibration:

AV Mode – Select CUSTOM to enable the Pro Settings for calibration.

Color Temp – Select WARM 1 or WARM 2 for color temperature closest to the D65 target.

Color Mgmt. – Select OFF.

C.A.T.S. – Select OFF.

Pro Settings/Gamma – Select 2.2 or 2.4 to test for best performance to selected target.

Pro Settings/Panel Brightness (backlight) – Select HIGH, MID or LOW to set desired luminance
level.

Pro Settings/AGC (auto brightness) – Select 0 to disable auto brightness for accurate
calibration.

White Balance – If you will be adjusting the White Balance multipoint controls (under More
Detailed Adjustment), first adjust the display’s Gain and Cutoff controls to get the white balance
tracking close to target. Adjust the Gain controls at 70% or 80% and adjust the Cutoff controls at
20% or 30%.
CalMAN AutoCal™:

Prior to CalMAN Grayscale AutoCal, set the display’s Brightness and Contrast controls to 50 and
100, respectively.

After AutoCal is complete, optimize the Brightness and Contrast controls for the viewing
conditions.