Rear view), Connect to a good chassis ground 1 3, Connect terminal 3 to your +12 vdc power supply – Star Headlight & Lantern STAR-PA RSK996P User Manual
Page 22
REV. -
7/12/02 PLITSTR280
REV. -
7/12/02 PLITSTR280
1.
Connect Terminal 1 shown in the above picture to a Good
Chassis Ground.
2.
Connect Terminal 2 shown in the picture above to the Red
wire which supplies power to your power pak.
3.
Connect Terminal 3 to your +12 VDC power supply.
4.
The above instructions will light
the switch when it is turned
on. If you would like to have the switch constantly lit swap
the hook-ups to Terminal 2 and Terminal 3.
1.
Connect Terminal 1 shown in the above picture to a Good
Chassis Ground.
2.
Connect Terminal 2 shown in the picture above to the Red
wire which supplies power to your power pak.
3.
Connect Terminal 3 to your +12 VDC power supply.
4.
The above instructions will light the switch when it is turned
on. If you would like to have the switch constantly lit swap the
hook-ups to Terminal 2 and Terminal 3.
CONNECT
TO A GOOD
CHASSIS
GROUND
1
3
(REAR VIEW)
CONNECT
TO +12 V
D
C
POWER OUT:
CONNECT TO
THE
RED WIRE FROM
POWER PAK
2
CONNECT
TO A GOOD
CHASSIS
GROUND
1
3
(REAR VIEW)
CONNECT
TO +12 V
D
C
POWER OUT:
CONNECT TO
THE
RED WIRE FROM
POWER PAK
2